橡胶研发用压缩*变形器
橡胶研发用压缩*变形器
Rubber compression deformation
The tester consists of parallel plate limiter and a fastening piece, with GB7759, ISO815 requirements for vulcanized rubber,
Under the condition of normal temperature, high temperature and low temperature, the rubber deformation was measured by a certain compression rate.
Two. Technical parameters of rubber compression deformation:
1 sample:
A diameter 29mm height 12.5mm
B diameter 13mm height 6.3mm
2 limiter height: specimen type A B
Compression rate 25% ~ 9.3 ~ 9.4 ~ 4.7 ~ 4.8
Compression rate 15% ~ 10.6 ~ 10.7 ~ 5.3 ~ 5.4
Compression rate 10% ~ 11.25 ~ 11.3 ~ 5.65 ~ 5.7
3 dimension: diameter 115mm high 110mm
4 weight: 10Kg
橡胶压缩变形器 http://www.jsfy17。。com/ParentList-561049.html
试验器由平行钢板限制器和紧固件组成,符合GB7759、ISO815要求,用于硫化橡胶,
热塑性橡胶在常温,高温和低温条件下,以一定压缩率,经一定的压缩时间后测定橡胶变形量。
二.橡胶压缩**变形器技术参数:
1.试样:
A型 直径29mm 高度12.5mm
B型 直径13mm 高度6.3mm
2.限制器高度:试样类型 A B
压缩率25%时 9.3~9.4 4.7~4.8
压缩率15%时 10.6~10.7 5.3~5.4
压缩率10%时 11.25~11.3 5.65~5.7
3.外形尺寸:直径115mm 高110mm
4.重量: 10Kg
橡胶研发用压缩*变形器